Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:sony_cdx_gt470um_car_radio [2023/03/20 18:32] – [Using the rear speakers as a subwoofer (Rear Bass Enhancer)] niccolo
+++ doc:appunti:hardware:sony_cdx_gt470um_car_radio [2023/03/21 09:05] (current) – [DM+ ON] niccolo
@@ Line 3: / Line 3: @@
 ==== Subwoofer connection ====
-**NOTICE**: You have to switch the device OFF to set this:
+It is necessary to inform the radio about the optionally connected subwoofer. It is possibile to attach a passive (not amplified) one directly to the head unit, or to use an amplified one through an amplifier. If you want to use the rear speakers instead of a subwoofer, you must use the REAR-OUT setting here. **NOTICE**: You have to switch the device OFF to access this setting:
   * GENERAL
@@ Line 28: / Line 28: @@
         * OFF, 50Hz, 60Hz, 80Hz, 100Hz, **120Hz**
       * **HPF SLOP**: Slope (steepness) of the high-pass filter curve (an higher slope means a more drastic cut-off).
-        * 1, 2 or **3**
+        * 1, **2** or 3
 ==== Using the rear speakers as a subwoofer (Rear Bass Enhancer) ====
-It is possibile to simulate the function of a subwoofer using the rear speakers. You can select the cut-off frequency for the sound to be sent to the rear speakers and the steepness (slope) of the cut-off curve.
+It is possibile to simulate the function of a subwoofer using the rear speakers. You can select the cut-off frequency for the sound to be sent to the rear speakers and the steepness (slope) of the cut-off curve. **NOTICE**: Set the subwoofer connection to REAR-OUT before.
-**NOTICE**: Set the subwoofer connection to REAR-OUT before.
   * SOUND
     * RB ENH
-      * **RBE MODE**
+      * **RBE MODE** No documentation exists about the differencies on modes.
-        * 1, 2, 3 or OFF
+        * **1**, 2, 3 or OFF
       * LPF FREQ
-        * 50Hz, 60Hz, 80Hz, 100Hz or 120Hz
+        * 50Hz, 60Hz, **80Hz**, 100Hz or 120Hz
       * LPF SLOP (an higher slope means a more drastic cut-off)
-        * 1, 2 or 3
+        * 1, **2** or 3
 ==== Alternative Frequencies restricted to the same region ====
-When the Alternative Frequencies option is enabled, the radio retunes the station to the strongest signal (it uses RDS to find stations of the same network). By default the searching is restricted to the same region, but you can disable this restriction.
+When the Alternative Frequencies option is enabled, the radio retunes the station to the strongest signal (it uses RDS to find stations of the same network). By default the searching is restricted to the same region, but you can disable this restriction. **NOTICE**: You have to tune an FM radio station to set this:
-**NOTICE**: You have to tune an FM radio station to set this:
   * GENERAL
@@ Line 57: / Line 53: @@
 ==== DM+ ON ====
-==== AUX VOLUME ====
+This digital filter is intended to restore high frequencies lost in the digital audio compression process. **NOTICE**: This settings is not available when the radio is on the TUNER source.
-If the volume of your AUX source is too different from e.g. the TUNER source, it is possible to adjust its volume, increasing or decreasing it.
+  * SOUND
+    * DM+
+      * **ON**
+==== AUX VOLUME ====
-**NOTICE**: Set the radio to the AUX source to set this.
+If the volume of your AUX source is too different from e.g. the TUNER source, it is possible to adjust its volume, increasing or decreasing it. **NOTICE**: Set the radio to the AUX source to set this.
   * SOUND
     * AUX VOL
-      * **dB**
+      * **+6dB**