doc:appunti:prog:python_program_execution
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
doc:appunti:prog:python_program_execution [2009/10/01 15:42] – niccolo | doc:appunti:prog:python_program_execution [2022/07/01 10:56] (current) – [Get the output of a program] niccolo | ||
---|---|---|---|
Line 17: | Line 17: | ||
</ | </ | ||
- | Same as above, but run in a subshell: | + | Same as above, but run in a subshell |
<code python> | <code python> | ||
- | retcode = call(" | + | retcode = subprocess.call(" |
</ | </ | ||
Line 28: | Line 28: | ||
<code python> | <code python> | ||
- | output = subprocess.Popen([" | + | output = subprocess.Popen([" |
</ | </ | ||
- | Get also the return code and iterate on the output: | + | Get also the return code, stderr |
<code python> | <code python> | ||
- | subproc = subprocess.Popen([" | + | subproc = subprocess.Popen([" |
- | output | + | output, stderr |
retcode = subproc.returncode | retcode = subproc.returncode | ||
- | for line in output.splitlines(): | + | for line in output.decode(' |
- | print line | + | print(line) |
+ | </ | ||
+ | |||
+ | ===== Redirect output to a file ===== | ||
+ | |||
+ | <code python> | ||
+ | file = open("/ | ||
+ | subprocess.call([" | ||
+ | file.close() | ||
+ | </ | ||
+ | |||
+ | ===== Run two commands in a pipe ===== | ||
+ | |||
+ | <code python> | ||
+ | cmd1 = [" | ||
+ | cmd2 = [" | ||
+ | p1 = subprocess.Popen(cmd1, | ||
+ | p2 = subprocess.Popen(cmd2, | ||
+ | p1.stdout.close() | ||
+ | output = p2.communicate()[0] | ||
+ | </ | ||
+ | |||
+ | ===== Write to command standard input ===== | ||
+ | |||
+ | <code python> | ||
+ | cmd_input = [] | ||
+ | cmd_input.append(' | ||
+ | cmd_input.append(' | ||
+ | |||
+ | p = subprocess.Popen(' | ||
+ | p.communicate(os.linesep.join(cmd_input)) | ||
</ | </ | ||
doc/appunti/prog/python_program_execution.1254404526.txt.gz · Last modified: 2009/10/01 15:42 by niccolo