doc:appunti:hardware:asus_eeepc_1215b_cmos_battery
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
doc:appunti:hardware:asus_eeepc_1215b_cmos_battery [2020/04/06 12:08] – niccolo | doc:appunti:hardware:asus_eeepc_1215b_cmos_battery [2020/04/06 12:08] (current) – niccolo | ||
---|---|---|---|
Line 3: | Line 3: | ||
The original **CMOS battery** into the **ASUS Eee PC 1215B** is a non-rechargeable lithium battery **CR2032**. The original package consist of the battery with two wires connected by welded metal plates. A plastic ring and an heat shrink tubing are used to prevent short circuits. | The original **CMOS battery** into the **ASUS Eee PC 1215B** is a non-rechargeable lithium battery **CR2032**. The original package consist of the battery with two wires connected by welded metal plates. A plastic ring and an heat shrink tubing are used to prevent short circuits. | ||
- | {{.: | + | {{.: |
- | {{.: | + | {{.: |
I replaced the exhausted battery, reusing the wires and the plastic ring. I removed the little metal plates, **soldering the wires directly over the battery** casing. Then I wrapped the battery with a new heat shring tube. | I replaced the exhausted battery, reusing the wires and the plastic ring. I removed the little metal plates, **soldering the wires directly over the battery** casing. Then I wrapped the battery with a new heat shring tube. | ||
- | {{.: | + | {{.: |
- | {{.: | + | {{.: |
doc/appunti/hardware/asus_eeepc_1215b_cmos_battery.txt · Last modified: 2020/04/06 12:08 by niccolo