====== GoPro Hero 10 Black ======

  * **[[gopro_sharpness]]**
  * **[[gopro_color_profile]]**

===== Common operations =====

=== Dashboard (p.98) and Preferences (p.100) ===

  * Rear touch screen => Swipe down => Dashboard
  * Dashboard => Swipe left => Preferences

=== Format SD Card ===

  * Preferences => Reset => Format SD Card

The filesystem used is **exFAT** for SD Card **64 GB** or more, otherwise **FAT32**.\\ :!: **WARNING**: Some Android versions does not support reading exFAT filesystem via OTG USB.

=== Camera Beeps ===

  * Dashboard => Camera Beeps icon => Enable/disable
  * Preferences => General => Beep Volume

=== Screen Orientation ===

  * Dashboard => Orientation Lock icon => Locked/All

=== Front Screen (p.16) ===

  * Dashboard => Front Screen Settings icon => Full Screen/Actual Screen/Status Only/Screen Off

=== Shortcuts in capture screen ===

  * Tap Capture settings => Pencil icon => Shortcuts

=== QuickCapture ===

If QuickCapture is enabled: with the camera off, press the shutter button; the camera turns on and starts recording immediately (lag 3 seconds). Pressing the shutter button again stops recording and the camera turns off.

  * Dashboard => QuickCapture icon => Enable/disable


===== Lens =====

^ SuperView                  |     16 mm |
^ Wide                       |  16-34 mm |
^ Linear                     |  19-39 mm |
^ Linear + Horizon Leveling  |  19-34 mm |
^ Narrow                     |     27 mm |


===== Stealth Mode =====

  * **Dashboard**
    * BEEPS: OFF
    * FRONT SCREEN OPTIONS: SCREEN OFF
  * **Preferneces**
    * General
      * LEDs: All Off
    * Display
      * Screen Saver Rear: 1 Min
      * Brightness: 10%

===== Horizon leveling =====

**{{.:gopro-hero-10:hero10-black-horizon-leveling.pdf|Horizon leveling max angles and FOV}}**

===== GoPro10 red charging lights stays on for hours and then stays on even after unplugging =====

[[https://community.gopro.com/s/question/0D53b00008oieEeCAI/gopro10-red-charging-lights-stays-on-for-hours-and-then-stays-on-even-after-unplugging-same-day-a-10-appears-on-the-screen-and-i-had-to-remove-the-battery-to-restart-any-ideas|community.gopro.com]]: This can happen if you're charging your GoPro via a PC usb port or a USB hub. Your GoPro requires a constant 5V 2.4A charge, however PC ports and USB hubs usually have a variable output and can switch between power and data modes.

In realtà il problema si è presentato più di una volta con un normale caricatore USB.

===== Does HindSight mode uses the SD card or RAM for buffering? =====

The [[https://community.gopro.com/s/article/HindSight-Information|GoPro support page]] does not give any information about that. Many speculated that the GoPro uses RAM (see [[https://www.reddit.com/r/gopro/comments/zy1e75/does_hindsight_buffer_to_card_or_another_place/|here]]), but the following error message (from this [[https://community.gopro.com/s/question/0D53b00008BtfknCAB/hero-10-hindsight-and-memory-card|post]]) may suggest otherwise:

{{:doc:appunti:hardware:gopro-hero-10:hindsight-stopped.jpg?direct&280|HindSight Stopped Error}}

===== Web References =====

  * **[[https://community.gopro.com/s/article/HERO10-Black-In-Camera-Horizon-Leveling?language=en_US|HERO10 Black: In-Camera Horizon Leveling]]**