GoPro Hero 10 Black

• GoPro Hero 10 sharpness settings
• GoPro Hero 10 color profiles

• Rear touch screen ⇒ Swipe down ⇒ Dashboard
• Dashboard ⇒ Swipe left ⇒ Preferences

• Preferences ⇒ Reset ⇒ Format SD Card

The filesystem used is exFAT for SD Card 64 GB or more, otherwise FAT32.
WARNING: Some Android versions does not support reading exFAT filesystem via OTG USB.

• Dashboard ⇒ Camera Beeps icon ⇒ Enable/disable
• Preferences ⇒ General ⇒ Beep Volume

• Dashboard ⇒ Orientation Lock icon ⇒ Locked/All

• Dashboard ⇒ Front Screen Settings icon ⇒ Full Screen/Actual Screen/Status Only/Screen Off

• Tap Capture settings ⇒ Pencil icon ⇒ Shortcuts

If QuickCapture is enabled: with the camera off, press the shutter button; the camera turns on and starts recording immediately (lag 3 seconds). Pressing the shutter button again stops recording and the camera turns off.

• Dashboard ⇒ QuickCapture icon ⇒ Enable/disable

• Dashboard
  • BEEPS: OFF
  • FRONT SCREEN OPTIONS: SCREEN OFF
• Preferneces
  • General
    • LEDs: All Off
  • Display
    • Screen Saver Rear: 1 Min
    • Brightness: 10%

Horizon leveling max angles and FOV

community.gopro.com: This can happen if you're charging your GoPro via a PC usb port or a USB hub. Your GoPro requires a constant 5V 2.4A charge, however PC ports and USB hubs usually have a variable output and can switch between power and data modes.

In realtà il problema si è presentato più di una volta con un normale caricatore USB.

The GoPro support page does not give any information about that. Many speculated that the GoPro uses RAM (see here), but the following error message (from this post) may suggest otherwise:

• HERO10 Black: In-Camera Horizon Leveling