doc:appunti:hardware:jumper_ezbook_s3
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
doc:appunti:hardware:jumper_ezbook_s3 [2018/08/01 09:28] – [TODO] niccolo | doc:appunti:hardware:jumper_ezbook_s3 [2018/08/01 09:31] (current) – [How To Make the WiFi Working] niccolo | ||
---|---|---|---|
Line 34: | Line 34: | ||
===== How To Make the WiFi Working ===== | ===== How To Make the WiFi Working ===== | ||
- | The integrated WiFi card is attached to the USB bus, it is identified by ID **obda: | + | The integrated |
The WiFi did not work with the stock installation. The **scanning** for available access points **is indeed working**, but **associating fails**. After the failed association, | The WiFi did not work with the stock installation. The **scanning** for available access points **is indeed working**, but **associating fails**. After the failed association, | ||
- | We downloaded the sources of a kernel module (developed by **lwfinger**) which expressly states the compatibility with that device. This is the source code **[[https:// | + | We downloaded the sources of a kernel module (developed by **lwfinger**) which expressly states the compatibility with that device |
< | < | ||
Line 45: | Line 45: | ||
git clone https:// | git clone https:// | ||
cd rtl8723bu | cd rtl8723bu | ||
- | # In Makefile: commented-out | + | # In Makefile: commented-out the line EXTRA_CFLAGS += -DCONFIG_CONCURRENT_MODE |
make | make | ||
make install | make install | ||
Line 100: | Line 100: | ||
* How to prevent the notebook to go into stand-by mode, which make it unreachable from the network (e.g. ssh login). | * How to prevent the notebook to go into stand-by mode, which make it unreachable from the network (e.g. ssh login). | ||
* Bluetooth not working? | * Bluetooth not working? | ||
- | * FIXME **Enter** key misbehaving in **less**. Problem: e.g. man page, backslash to search, hit Enter does not work, it prints **ESCOM** string instad. Workaround: use **Ctrl-M**. Tips: '' | + | * FIXME **Enter** key misbehaving in **less**. Problem: e.g. man page, backslash to search, hit Enter does not work, it prints **ESCOM** string instad. Workaround: use **Ctrl-M**. Tips: '' |
doc/appunti/hardware/jumper_ezbook_s3.1533108488.txt.gz · Last modified: 2018/08/01 09:28 by niccolo