doc:appunti:hardware:power_meter_pm300
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
doc:appunti:hardware:power_meter_pm300 [2009/11/01 09:54] – niccolo | doc:appunti:hardware:power_meter_pm300 [2010/01/11 14:14] (current) – niccolo | ||
---|---|---|---|
Line 4: | Line 4: | ||
**{{pm300-power-meter-english.pdf|User manual}}** | **{{pm300-power-meter-english.pdf|User manual}}** | ||
+ | |||
+ | === Quick User Guide === | ||
+ | |||
+ | **MEASUREMENT** | ||
+ | * Press A(UP) key to select Voltage , Amp, Max AMP Watt, Max Watt and Overload Display | ||
+ | * Press B(DOWN) key to select KWh, Total Cost and Price | ||
+ | **SET PRICE** | ||
+ | * Press B(DOWN) key to select Price display Mode | ||
+ | * Press D(PRICE SET) key to enter Price Setting Mode | ||
+ | * Use A(UP) or B(DOWN) key to adjust price and press D(PRICE SET) key to confirm | ||
+ | **SET OVERLOAD WARNING** | ||
+ | * Press A (UP) key to select Overload Display Mode | ||
+ | * Press C (Overload Set) key to enter Overload Setting Mode | ||
+ | * Press A(UP) or B(DOWN) key to select desired W or A | ||
+ | * Press C (Overload Set) key to enter to Value Setting Mode | ||
+ | * Use A(UP) or B(DOWN) to adjust to desired value of Over Load Watt or Amp and press C(OVERLOAD SET) key to confirm | ||
+ | **CLEAR MAX LOAD** | ||
+ | * Press and hold A (UP) & C(OVERLOAD SET) key for 3 seconds to clear the Max Load readings and buzzer beep | ||
+ | **CLEAR USAGE READING** | ||
+ | * Press and hold B (DOWN) & D(PRICE SET) key for 3 seconds to clear "usage time " and " | ||
+ |
doc/appunti/hardware/power_meter_pm300.1257065641.txt.gz · Last modified: 2009/11/01 09:54 by niccolo