doc:appunti:hardware:raspberrypi_abbaiometro
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
doc:appunti:hardware:raspberrypi_abbaiometro [2015/12/10 15:32] – niccolo | doc:appunti:hardware:raspberrypi_abbaiometro [2015/12/10 15:34] (current) – niccolo | ||
---|---|---|---|
Line 5: | Line 5: | ||
{{.: | {{.: | ||
- | I used a sound sensor based on the **LM393** comparator IC. It is advertised as an Arduino | + | I used a sound sensor based on the **LM393** comparator IC. It is advertised as an Arduino |
==== Usage ==== | ==== Usage ==== | ||
- | Connect the **+** and **G** pins to **5 VCC** and **ground** respectively: | + | Connect the **+** and **G** pins to **5 VCC** and **ground** respectively: |
The **L2 LED** will turn ON when the sound level is above the threshold, which is regulated with the **trimmer potentiometer**. The POT is a multi turn (may be 10?) potentiometer: | The **L2 LED** will turn ON when the sound level is above the threshold, which is regulated with the **trimmer potentiometer**. The POT is a multi turn (may be 10?) potentiometer: | ||
When the sound is above the threshold, a digital **high signal** is sent across the **DO** (digital output) pin. | When the sound is above the threshold, a digital **high signal** is sent across the **DO** (digital output) pin. |
doc/appunti/hardware/raspberrypi_abbaiometro.1449757943.txt.gz · Last modified: 2015/12/10 15:32 by niccolo