Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:raspberrypi_micromediahub [2018/01/02 18:35] – [Problem Decoding Webm (VP8 Encoded) Videos] niccolo
+++ doc:appunti:hardware:raspberrypi_micromediahub [2020/09/28 20:45] (current) – [Kodi] niccolo
@@ Line 9: / Line 9: @@
   * Joystick controller
   * LCD display 16x2 charaters
+====== Current consumption ======
+See **[[https://www.raspberrypi.org/documentation/faqs/#powerReqs|FAQS PowerReqs]]**.
+  * **Raspberry Pi 3 Model B**
+    * 1GB RAM
+    * Typical bare-board active current consumption: 400mA
+    * Maximum total USB peripheral current draw: 1.2A
+    * Recommended PSU current capacity: 2.5A
+  * **Raspberry Pi 3 Model A+**
+    * 512MB LPDDR2 SDRAM
+    * Typical bare-board active current consumption: 350mA
+    * Maximum total USB peripheral current draw: Limited by PSU, board, and connector ratings only.
+  * **Toshiba Canvio Basics 1Tb**
+    * USB bus power (max. 900mA)
 ====== Kodi ======
@@ Line 20: / Line 36: @@
 Kodi will not start automatically at boot, just execute **kodi-standalone** from the command line.
-**NOTICE**: Raspbian includes **Kodi version 17.6** whereas Debian Stretch has Kodi 17.1, so beware of what packages you are installing and respect the right dependencies.
+**NOTICE**: Raspbian based on **Debian Stretch 9.11** uses two repositories:
+  * **[[http://raspbian.raspberrypi.org/raspbian/]]** (by file /etc/apt/sources.list)
+  * **[[http://archive.raspberrypi.org/debian/]]** (by file /etc/apt/sources.list.d/raspi.list)
+The first repository provides **Kodi 17.1** as per Debian Stretch. The second repository provided **Kodi version 17.6** on December 2017, but it was upgraded to **Kodi version 18** on february 2019. So beware of what packages you are installing, respect the right dependencies and be carefull with upgrades.
+Our current installation uses these versions:
+^ kodi                         | 2:17.6-2~stretch  |
+^ kodi-bin                     | 2:17.6-2~stretch  |
+^ kodi-eventclients-common     | 2:18.1-1~stretch  |
+^ kodi-eventclients-kodi-send  | 2:18.1-1~stretch  |
+^ kodi-peripheral-joystick     | 1.3.4-1~stretch   |
+^ libkodiplatform17:armhf      | 17.4.0~stretch    |
+To activate a joypad you have to go through **//Settings//** => //System settings// => //Input// => **//Configure attacched controllers//**.
 ===== Starting Kodi at Boot =====