doc:appunti:hardware:raspberrypi_nas_kodi
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:appunti:hardware:raspberrypi_nas_kodi [2022/05/28 18:01] – [RaspiOS 11 Bullseye] niccolo | doc:appunti:hardware:raspberrypi_nas_kodi [2022/08/10 09:49] – [Swap file] niccolo | ||
---|---|---|---|
Line 30: | Line 30: | ||
Another usefull option is **arm_boost=1**, | Another usefull option is **arm_boost=1**, | ||
+ | Check for other unnecessary configuration options in **[[https:// | ||
+ | |||
+ | ==== Swap file ==== | ||
+ | |||
+ | The default RaspiOS installation will enable a swap file to support system memory. Using the **free** command you can see that a 100 Mb swap file was enabled: | ||
+ | |||
+ | < | ||
+ | | ||
+ | Mem: | ||
+ | Swap: | ||
+ | </ | ||
+ | |||
+ | The swap file is **/ | ||
+ | |||
+ | < | ||
+ | systemctl stop dphys-swapfile.service | ||
+ | systemctl disable dphys-swapfile.service | ||
+ | </ | ||
+ | |||
+ | ==== Web References ==== | ||
+ | |||
+ | * **[[https:// | ||
+ | * **[[https:// | ||
* **[[https:// | * **[[https:// | ||
* **[[https:// | * **[[https:// | ||
* **[[https:// | * **[[https:// | ||
- | |||
- | Check for other unnecessary configuration options in **[[https:// | ||
- | |||
===== RaspiOS 10 Buster ===== | ===== RaspiOS 10 Buster ===== |
doc/appunti/hardware/raspberrypi_nas_kodi.txt · Last modified: 2023/06/10 17:24 by niccolo