tecnica:meccanica:vector_welding_mig_130
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tecnica:meccanica:vector_welding_mig_130 [2025/03/12 16:54] – niccolo | tecnica:meccanica:vector_welding_mig_130 [2025/03/12 17:08] (current) – [Web references] niccolo | ||
|---|---|---|---|
| Line 598: | Line 598: | ||
| * **Wire spool size**: 16 x 100 mm diameter (inner x outer) x 44 mm. | * **Wire spool size**: 16 x 100 mm diameter (inner x outer) x 44 mm. | ||
| + | * **Wire type**: The most common designations are **E71T-11** and **E71T-GS**. The //-11// is a wire for all positions and multi-pass welding while the //-GS// is a //general standard// usually suited for a single pass welding. | ||
| * **Contact tip**: the tip has an M6 thread x 25 mm lenght. The torch consumables (tip and nozzle) should be compatible with the //Binzel standard// MIG torches **MB15**, also labeled as **AK15** by other manufacturers. | * **Contact tip**: the tip has an M6 thread x 25 mm lenght. The torch consumables (tip and nozzle) should be compatible with the //Binzel standard// MIG torches **MB15**, also labeled as **AK15** by other manufacturers. | ||
| * **Nozle**: 12 mm inner diameter, 52 mm lenght. | * **Nozle**: 12 mm inner diameter, 52 mm lenght. | ||
| Line 669: | Line 670: | ||
| * **[[https:// | * **[[https:// | ||
| * **[[https:// | * **[[https:// | ||
| + | * **[[https:// | ||
tecnica/meccanica/vector_welding_mig_130.1741794865.txt.gz · Last modified: 2025/03/12 16:54 by niccolo