tecnica:motori:honda_ntv650_carburetor
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tecnica:motori:honda_ntv650_carburetor [2026/04/08 22:32] – [Problem with the Keyster valve seat] niccolo | tecnica:motori:honda_ntv650_carburetor [2026/04/08 22:34] (current) – [Problem with the Keyster valve seat] niccolo | ||
|---|---|---|---|
| Line 103: | Line 103: | ||
| ===== Problem with the Keyster valve seat ===== | ===== Problem with the Keyster valve seat ===== | ||
| - | After overhauling the carburetors with the Keyster kit, I had a problem with the float valve seat. Even though I had adjusted the float level according to the manual (9.2 mm), after driving for a few kilometers, the fuel began dripping from the carburetor vent tube. Evidently the valve wasn't closing, and the float chamber was overfilling. | + | After overhauling the carburetors with the Keyster kit, I had **a problem with the float valve seat**. Even though I had adjusted the float level according to the manual (9.2 mm), after driving for a few kilometers, the fuel began dripping from the carburetor vent tube. Evidently the valve wasn't closing, and **the float chamber was overfilling**. |
| - | To confirm that the fuel level was the problem, I connected two clear rubber hoses to the carburetor drains. The hoses were then bent upward, above the fuel cap. By loosening the **drain | + | To confirm that the fuel level was the problem, I connected two clear rubber hoses to the carburetor drains. The hoses were then bent upward, above the fuel cap. By loosening the **drain |
| {{.: | {{.: | ||
tecnica/motori/honda_ntv650_carburetor.1775680353.txt.gz · Last modified: by niccolo
