Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:gopro-hero-10 [2024/12/04 15:34] – [Horizon leveling] niccolo
+++ doc:appunti:hardware:gopro-hero-10 [2026/06/17 06:02] (current) – [GoPro10 red charging lights stays on for hours and then stays on even after unplugging] niccolo
@@ Line 1: / Line 1: @@
 ====== GoPro Hero 10 Black ======
+  * **[[gopro_sharpness]]**
+  * **[[gopro_color_profile]]**
 ===== Common operations =====
@@ Line 5: / Line 8: @@
 === Dashboard (p.98) and Preferences (p.100) ===
-  * Capture settings in rear touch screen => Swipe down => Dashboard
+  * Rear touch screen => Swipe down => Dashboard
   * Dashboard => Swipe left => Preferences
@@ Line 11: / Line 14: @@
   * Preferences => Reset => Format SD Card
+The filesystem used is **exFAT** for SD Card **64 GB** or more, otherwise **FAT32**.\\ :!: **WARNING**: Some Android versions does not support reading exFAT filesystem via OTG USB.
 === Camera Beeps ===
@@ Line 24: / Line 29: @@
   * Dashboard => Front Screen Settings icon => Full Screen/Actual Screen/Status Only/Screen Off
+=== Shortcuts in capture screen ===
+  * Tap Capture settings => Pencil icon => Shortcuts
+=== QuickCapture ===
+If QuickCapture is enabled: with the camera off, press the shutter button; the camera turns on and starts recording immediately (lag 3 seconds). Pressing the shutter button again stops recording and the camera turns off.
+  * Dashboard => QuickCapture icon => Enable/disable
 ===== Lens =====
@@ Line 33: / Line 49: @@
 ^ Narrow                     |     27 mm |
+===== Stealth Mode =====
+  * **Dashboard**
+    * BEEPS: OFF
+    * FRONT SCREEN OPTIONS: SCREEN OFF
+  * **Preferneces**
+    * General
+      * LEDs: All Off
+    * Display
+      * Screen Saver Rear: 1 Min
+      * Brightness: 10%
 ===== Horizon leveling =====
 **{{.:gopro-hero-10:hero10-black-horizon-leveling.pdf|Horizon leveling max angles and FOV}}**
+===== GoPro10 red charging lights stays on for hours and then stays on even after unplugging =====
+[[https://community.gopro.com/s/question/0D53b00008oieEeCAI/gopro10-red-charging-lights-stays-on-for-hours-and-then-stays-on-even-after-unplugging-same-day-a-10-appears-on-the-screen-and-i-had-to-remove-the-battery-to-restart-any-ideas|community.gopro.com]]: This can happen if you're charging your GoPro via a PC usb port or a USB hub. Your GoPro requires a constant 5V 2.4A charge, however PC ports and USB hubs usually have a variable output and can switch between power and data modes.
+In realtà il problema si è presentato più di una volta con un normale caricatore USB.
+===== Does HindSight mode uses the SD card or RAM for buffering? =====
+The [[https://community.gopro.com/s/article/HindSight-Information|GoPro support page]] does not give any information about that. Many speculated that the GoPro uses RAM (see [[https://www.reddit.com/r/gopro/comments/zy1e75/does_hindsight_buffer_to_card_or_another_place/|here]]), but the following error message (from this [[https://community.gopro.com/s/question/0D53b00008BtfknCAB/hero-10-hindsight-and-memory-card|post]]) may suggest otherwise:
+{{:doc:appunti:hardware:gopro-hero-10:hindsight-stopped.jpg?direct&280|HindSight Stopped Error}}
 ===== Web References =====
   * **[[https://community.gopro.com/s/article/HERO10-Black-In-Camera-Horizon-Leveling?language=en_US|HERO10 Black: In-Camera Horizon Leveling]]**