rigacci.org

User Tools

Site Tools

Trace: • GoPro Hero 10 Black
doc:appunti:hardware:gopro-hero-10

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
doc:appunti:hardware:gopro-hero-10 [2024/12/04 15:39] – [Common operations] niccolodoc:appunti:hardware:gopro-hero-10 [2026/06/17 06:02] (current) – [GoPro10 red charging lights stays on for hours and then stays on even after unplugging] niccolo
Line 1: Line 1:
 ====== GoPro Hero 10 Black ====== ====== GoPro Hero 10 Black ======
 +
 +  * **[[gopro_sharpness]]**
 +  * **[[gopro_color_profile]]**
  
 ===== Common operations ===== ===== Common operations =====
Line 11: Line 14:
  
   * Preferences => Reset => Format SD Card   * Preferences => Reset => Format SD Card
 +
 +The filesystem used is **exFAT** for SD Card **64 GB** or more, otherwise **FAT32**.\\ :!: **WARNING**: Some Android versions does not support reading exFAT filesystem via OTG USB.
  
 === Camera Beeps === === Camera Beeps ===
Line 44: Line 49:
 ^ Narrow                     |     27 mm | ^ Narrow                     |     27 mm |
  
 +
 +===== Stealth Mode =====
 +
 +  * **Dashboard**
 +    * BEEPS: OFF
 +    * FRONT SCREEN OPTIONS: SCREEN OFF
 +  * **Preferneces**
 +    * General
 +      * LEDs: All Off
 +    * Display
 +      * Screen Saver Rear: 1 Min
 +      * Brightness: 10%
  
 ===== Horizon leveling ===== ===== Horizon leveling =====
  
 **{{.:gopro-hero-10:hero10-black-horizon-leveling.pdf|Horizon leveling max angles and FOV}}** **{{.:gopro-hero-10:hero10-black-horizon-leveling.pdf|Horizon leveling max angles and FOV}}**
 +
 +===== GoPro10 red charging lights stays on for hours and then stays on even after unplugging =====
 +
 +[[https://community.gopro.com/s/question/0D53b00008oieEeCAI/gopro10-red-charging-lights-stays-on-for-hours-and-then-stays-on-even-after-unplugging-same-day-a-10-appears-on-the-screen-and-i-had-to-remove-the-battery-to-restart-any-ideas|community.gopro.com]]: This can happen if you're charging your GoPro via a PC usb port or a USB hub. Your GoPro requires a constant 5V 2.4A charge, however PC ports and USB hubs usually have a variable output and can switch between power and data modes.
 +
 +In realtà il problema si è presentato più di una volta con un normale caricatore USB.
 +
 +===== Does HindSight mode uses the SD card or RAM for buffering? =====
 +
 +The [[https://community.gopro.com/s/article/HindSight-Information|GoPro support page]] does not give any information about that. Many speculated that the GoPro uses RAM (see [[https://www.reddit.com/r/gopro/comments/zy1e75/does_hindsight_buffer_to_card_or_another_place/|here]]), but the following error message (from this [[https://community.gopro.com/s/question/0D53b00008BtfknCAB/hero-10-hindsight-and-memory-card|post]]) may suggest otherwise:
 +
 +{{:doc:appunti:hardware:gopro-hero-10:hindsight-stopped.jpg?direct&280|HindSight Stopped Error}}
  
 ===== Web References ===== ===== Web References =====
  
   * **[[https://community.gopro.com/s/article/HERO10-Black-In-Camera-Horizon-Leveling?language=en_US|HERO10 Black: In-Camera Horizon Leveling]]**   * **[[https://community.gopro.com/s/article/HERO10-Black-In-Camera-Horizon-Leveling?language=en_US|HERO10 Black: In-Camera Horizon Leveling]]**
doc/appunti/hardware/gopro-hero-10.1733323181.txt.gz · Last modified: by niccolo