Differences

This shows you the differences between two versions of the page.

--- doc:appunti:hardware:olympus-e-m10:olympus_e_m10_mark_ii_failuers [2025/11/10 15:32] – [Olympus E-M10 Mark II failures] niccolo
+++ doc:appunti:hardware:olympus-e-m10:olympus_e_m10_mark_ii_failuers [2025/11/10 17:22] (current) – niccolo
@@ Line 22: / Line 22: @@
 {{olympus-e-m10-mark-ii-replacing-lcd-cable-4.jpg?180|}}
-===== Shutter actuations hidden menu =====
-  - Turn the camera ON while holding down the MENU button;
-  - Once the LCD screen lights up, release the MENU button and then press it again brieﬂy;
-  - Use the arrow pad to move DOWN to the SPANNER item in the menu and press RIGHT;
-  - Use the arrow pad to move DOWN to the BRIGHTNESS item in the menu and press RIGHT;
-  - Press INFO;
-  - Press OK, and a screen showing the camera designation will come up;
-  - Press arrow pad UP;
-  - Press arrow pad DOWN;
-  - Press arrow pad LEFT;
-  - Press arrow pad RIGHT;
-  - Press the SHUTTER RELEASE button;
-  - Press arrow pad UP (a PAGE 1 with some abbreviations and numbers appears);
-  - Press arrow pad RIGHT to move to PAGE 2;
-  - Write down the number to the right of "R" of "MS" on PAGE 2. This is the number of shutter releases (the number to the right of "S" is the number of times the ﬂash has ﬁred);
-  - Switch the camera Off to revert back to normal operating mode. Congratulations, you have successfully retrieved the shutter count information!
-^  Hidden menu codes  ^^
-^ Letter  ^ Interpretation  ^
-| R or MS  | Total shot count  |
-| S        | Total shots with ﬂash  |
-| C        | (unknown)  |
-| U        | Switch On count  |
-| V        | (unknown)  |
-| B        | Total shots with IBIS  |
-| L        | (unknown)  |
-{{:doc:appunti:hardware:olympus-e-m10:olympus-em10-service-menu-p2.jpg?200|}}
 ===== Web Resources =====