In November 2019 I purchased the Olympus E-M10 Mark II. Unfortunately I exprienced some hardware failure after about five years: here I write about them. To read the counter of the total show and the switch-on cycles, see this page: Menu nascosto: contatore scatti.

In September 2024, after near five years of use (the counters were showing about 4300 switch-on and 12600 total shots) the M.Zuiko 12-42 mm pancake lens failed. When you turn on the camera the lens moves, but it is not aknowledged by the camera and the LCD monitor remains black.

I purchased a second-hand replacement (same brand and model) which was in a excellent condition, almost like new. The number of switch-on of this second-hand lens were unknown. Unfortunately also this lens after one year and about 450 more switch-on, failed like the first one.

In May 2024, five and a half years after the purchase (the counters were supposedly 4500 switch-on and 14000 shots), the LCD monitor cable broke. Initially, the monitor would shut off when I rotated it from its resting position, but then the failure began to occur more and more frequently until the monitor was permanently off.

I purchased a replacement cable from a Chinese seller on the Aliexpress online store, the cost was just 5 € shipping included. Disassembling the monitor and replacing the cable is a job of medium difficulty, you can find some howto videos online. The result was very satisfactory. The careful disassembly did not damage the various components, and after reassembly, the camera was undamaged and fixed.

Here below some still images from the video Sostituzione flex cable Olympus OMD EM 10mkIl parte prima e parte seconda, where the cable is replaced (requires some soldering too):

• Olympus mFT shutter count
• How to access hidden codes on most Olympus E-System, Pen, XZ-1&2 and OM-D cameras