doc:appunti:hardware:raspberry_networking
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
doc:appunti:hardware:raspberry_networking [2022/02/09 11:22] – [/etc/dhcpcd.conf] niccolo | doc:appunti:hardware:raspberry_networking [2023/06/11 11:41] (current) – [/etc/dhcpcd.conf] niccolo | ||
---|---|---|---|
Line 22: | Line 22: | ||
< | < | ||
interface eth0 | interface eth0 | ||
- | static ip_address=10.0.0.72 | + | static ip_address=10.0.0.72/24 |
static routers=10.0.0.189 | static routers=10.0.0.189 | ||
static domain_name_servers=8.8.4.4 10.0.0.189 | static domain_name_servers=8.8.4.4 10.0.0.189 | ||
</ | </ | ||
- | Per configurare **eth0 con DHCP e fallback con profilo statico**: | + | Per configurare **eth0 con DHCP e fallback con profilo statico**. La configurazione statica viene applicata solo quando la Ethernet sente la portante (carrier attivo, cavetto inserito) e dopo un timeout di circa 30 secondi. |
< | < | ||
profile static_eth0 | profile static_eth0 | ||
- | static ip_address=10.0.0.72 | + | static ip_address=10.0.0.72/24 |
static routers=10.0.0.189 | static routers=10.0.0.189 | ||
static domain_name_servers=8.8.4.4 10.0.0.189 | static domain_name_servers=8.8.4.4 10.0.0.189 | ||
Line 38: | Line 38: | ||
fallback static_eth0 | fallback static_eth0 | ||
</ | </ | ||
+ | |||
+ | Per configurare **wlan0** tramite **DHCP** è necessario configurare il file **/ | ||
+ | |||
+ | < | ||
+ | country=IT | ||
+ | ctrl_interface=DIR=/ | ||
+ | update_config=1 | ||
+ | network={ | ||
+ | ssid=" | ||
+ | psk=" | ||
+ | } | ||
+ | </ | ||
+ | |||
+ | Per configurare **wlan0** con **IP statico**, oltre alla configurazione del file ''/ | ||
+ | |||
+ | < | ||
+ | interface wlan0 | ||
+ | static ip_address=10.0.0.73/ | ||
+ | static routers=10.0.0.189 | ||
+ | static domain_name_servers=8.8.4.4 | ||
+ | </ | ||
+ | |||
+ | ==== Configurare il WiFi con raspi-config ==== | ||
+ | |||
+ | Se si desidera una configurazione guidata dell' | ||
+ | |||
+ | * Localization Options => Wlan Country | ||
+ | * System Options => Wireless LAN | ||
+ | |||
+ | Entrambe le impostazioni verrano scritte in **/ | ||
===== Network Manager ===== | ===== Network Manager ===== | ||
Line 44: | Line 74: | ||
FIXME: Qual' | FIXME: Qual' | ||
+ | |||
+ | ===== Configurazione legacy con / | ||
+ | |||
+ | Se si desidera continuare ad utilizzare il file **/ | ||
+ | |||
+ | < | ||
+ | systemctl disable dhcpcd.service | ||
+ | systemctl disable wpa_supplicant.service | ||
+ | </ | ||
+ | |||
===== Altre pagine (più o meno aggiornate) ===== | ===== Altre pagine (più o meno aggiornate) ===== | ||
doc/appunti/hardware/raspberry_networking.1644402151.txt.gz · Last modified: 2022/02/09 11:22 by niccolo