Differences

This shows you the differences between two versions of the page.

--- doc:appunti:linux:lenovo_thinkpad_l380 [2025/12/07 06:24] – [Battery] niccolo
+++ doc:appunti:linux:lenovo_thinkpad_l380 [2025/12/07 06:26] (current) – [Battery] niccolo
@@ Line 86: / Line 86: @@
 <code>
 # Battery charge level below which charging will begin when connecting the charger.
-START_CHARGE_THRESH_BAT0=75
+START_CHARGE_THRESH_BAT0=80
 # Battery charge level above which charging will stop while the charger is connected.
-STOP_CHARGE_THRESH_BAT0=80
+STOP_CHARGE_THRESH_BAT0=85
 </code>
@@ Line 109: / Line 109: @@
 :!: **NOTICE**: As noted above, after you set the **charge_control_end_threshold**, its value is reported incorrectly by ''tlp-stat --battery'' (it shows a value equal to the charge_control_start_threshold) despite it is working as expected. So also the **Recommendations** shown by the tlp-stat command are misleading. Notice also that setting the **charge_control_start_threshold** to zero will automatically set the **charge_control_end_threshold** to 100.
-You can also trigger a battery charge to the full capacity (according to the vendor presets) issuing the command:
+You can also trigger a battery charge to the full capacity (according to the vendor presets) issuing the command (FIXME check if this is actually working):
 <code>