User Tools

Site Tools


doc:appunti:android:osmand_on_motorbike

This is an old revision of the document!


Using OsmAnd on a motorbike

In this article I write some notes about using and Android device (actually a smartphone) as a GPS navigation system on a motorbike. The choosen software is OsmAnd; a mature and full-featured navigation system based on the OpenStreetMap geographic data. I tested two different smartphones: a ZTE Blade A610 and an Oukitel WP12.

Mounting

Waterproof

The ZTE is not waterproof, so I can only use it when the weather is nice. Instead the WP12 is rated as IP68, i.e. it should be dust-proof and it should resist even to immersion into water, 1 meter depth.

However, the water resistance of the WP12 is ensured by a rubber plug protecting the power connector, so it is not possible to keep the smartphone charging when it rains.

The charging cable

12V power charger

Magnetic connector

Screen brightness

Reading the screen even under a brigth sun is a must-to-have for a motorbike navigation system. It is not simple to know the brightness specification of a smartphone, especially for the low-end models. In my case the ZTE performed noticeably better than the WP12. From the following photo you cand barely notice that the ZTE screen (on the left) is brighter than the other (WP12 on the right); the JPEG image measures a brightness higher by only a 4%, but the user experience with the ZTE is actually better.

Screen brightness: ZTE Blade A610 vs Oukitel WP12

Overheating

doc/appunti/android/osmand_on_motorbike.1659974631.txt.gz · Last modified: 2022/08/08 18:03 by niccolo